departmental bulletin paper

Departmental Bulletin Paper

Text

Transactions of JWRI. 2013, 42(1), p. 39-62

Diffusible Hydrogen in Steel Weldments : A Status Review

English

Text

2013-06

Despite being a subject of intense research and exclusive attention over the past several decades, hydrogen in the weldments of high strength steels continues to seriously limit the performance of the components and confounds the quantitative component prognosis. More than 1500 studies in the literature have reported the behavior and effects of hydrogen in steels and their welds. It is well documented that a sufficient amount of hydrogen, when combined with a crack susceptible microstructure and the weld residual stress, poses a greater risk of hydrogen assisted cracking (HAC). Cracking is undesirable in a weld because it causes a reduction in the mechanical properties, and thus poses a potential threat towards the structural integrity of the weldment. Of particular concern are the facts that HAC occurs at ambient temperatures, appears hours or days after the completion of welding and the cracks often remains undetected. Therefore, HAC may also cause catastrophic failure of a weld component while in service. It is known that the risk of cracking in welds can be reduced either by eliminating or by lowering at least one of the three following factors, the weld hydrogen content, the residual tensile stress and the crack susceptible microstructure of the weld, to levels below the critical to cause HAC. Reduction of hydrogen content in the weld is considered as the best way of reducing the risk of HAC. This can be achieved by employing dehydrogenation heat treatments to the steel and the weld. To choose a suitable dehydrogenation temperature, a knowledge of the hydrogen content in the weld is essential. Hydrogen in the steel weldments exists as diffusible and residual hydrogen. At a given temperature, while the residual hydrogen is permanently trapped in the weld and plays no role in HAC, the diffusible hydrogen is able to diffuse within or out of the weldment and is responsible for HAC. This brings out to the fore the need for the determination of diffusible hydrogen content in a weld. However, hydrogen is a transient element in steel and does not await its measurement like other elements. Therefore, development of a standard specimen and a standard procedure for the measurement of diffusible hydrogen is a daunting task. However, during the past few decades, several methods have been developed, tested and standardized for this purpose. This paper presents an overview of different aspects of hydrogen in steel welds and a systematic review of the different methods developed over the years for diffusible hydrogen measurement in steel welds.

10.18910/26593

26593

Diffusible Hydrogen in Steel Weldments : A Status Review

大阪大学接合科学研究所

English

2013-06

Transactions of JWRI

42

1

39

62

https://hdl.handle.net/11094/26593

10.18910/26593

https://doi.org/10.18910/26593